Any advice on installing a Novi 1500

Hello,
I have purchased a Novi 1500 Supercharger Head and I am going to install it on my 440 Cuda. I am a DIY guy because that is the only way i can afford the Hobby. Good and Bad, I do everything on my Cars. That being said, I am looking for any advice, technical, part suppliers, carbs, ect. I will try and post pics as i go of my Supercharger build?
DonorSupercharger is mounting on the drivers side
Engine( I am going to run 10psi tops)
446 w 906 heads - 3 angle valve job
Kieth Block pistons hyper,s -should i change them?
9.5 to 1 but going to increase to 8 to 1 with a gasket
Should I install a main stud Girdle?
The cam is a 528 purple stick, 112 lobe seperation plus I am using 1.6 ratio rockers, plan on using this same Cam
Carb- Plan on buying a used 4150 850 Holley?
I plan on using Exhaust pipe(stainless or Aluminized) for piping?
I NEED TO MAKE MY OWN PLATE(If Bill Dedman reads this can you help me locate a Blower drive plate?) Installing on same side as your valiant
SHOULD I USE 1/2 in or 3/4 inch AL plate?( i have a bridgeport but if I can buy that great looking waterjet cut piece that Dedman used would be GREAT!!
ANY TIPS ARE GREATLY APPRECIATED!!!!!

Can i use an Aeromotive bypass regulator vs a boost referanced Reg with an Aeromotive Street/Strip Elec Fuel Pump 150GPH ?

Anybody..?.don't make me go to HAMB -though they are a friendly bunch and they love DIY dudes like me that just don't plunk down the cash because that's the way