Clutch adjustment help needed!!!

I'm did the trans/clutch swap without pulling the bellhousing. I pulled the pilot bearing and installed an "automatic" pilot bushing. That seemed to seat good, but I had questions about whether it was in far enough especially since it fit nicely on the input shaft but not all the way to the splines. It was about 3/4 inch shy. (The shaft has a slightly raised area prior to the splines). Well guess what? The tranny slid in smooth to about 3/4 inch shy on touching the bellhousing. Pulling it again this morning. I'll get it right sooner or later. I really need a lift.