1969 Dodge Dart Pro-Street 440

Drive shaft is installed, but theres another problem ...lol figures. The front drive shaft loop was hitting the top of the driveshaft. No problem right? Just cut a new set of holes and move the top half of the loop up. Boom! No prob. Finially got enought altitude to get the u joint on the pinion yolk and then i notice that theres about a 1/4 in of room between the shaft and the trans tunnel. :violent1::violent1:

After closer inspection of the rear end, the pinion was pitched up! Thats fine, i have a 4 link, just contract the top two links and extend the bottom two and that will tilt the rear end forward right?

Has anyone adjusted 4 links? Im guessing that how it works. And then ill just have to measure the lingth of the rods and make them match so i know that they are straight.