Wiring help!!!!!!

Why not fix what's there and do it right? Can you read a diagram? What do you have for a diagram or shop manual?

You have TWO ignition sources, one for start, one for run. There's a brown wire coming out of your bulkhead connector goes to the ballast terminal which feeds the coil+ wire. THIS wire comes from the IGN switch and is "same as battery" in start. It is the ONLY source of ignition voltage for starting, because the "run" wire goes dead.

This wire is not shown in the diagram above, it would go to the bottom right ballast terminal

When you release the key to "run" then IGN 1 "run" comes alive and feeds power to the far top right corner of the page