Mr Gasket fuel line question

Is this the fitting that screws into the carburetor? If it is, all the Teflon tape and sealer in the world won't make a hill of beans difference, because that's not where the fittings seal. Those are flare fittings and seal on the inside where the flare is. If that's what was leaking, that means the flare was not made properly on the carburetor or the fuel line.

Nevermind. I looked at your link. That fitting should have two compression washers that go on either side of the banjo end. One between the banjo end and the bolt head and the other between the banjo end and the carburetor. This is the same type connection as a front brake caliper. Once again, the threads do NOT seal here folks, so thread tape and sealant are NOT what to use. If it did not come with two compression washers either go to the hardware store and get two copper or aluminum compression washers the right size, or send that JUNK back. Any type sealant or tape used there is WRONG WRONG WRONG.