1972 Canadian H-Code 340 Dart Swinger Special Resto - Finally started!
Dealing with this pain in the butt gap took quite a bit more time then I thought it would.
Decided I had to cut the lip off and section in some steel then cut that off back to where the lip would then line up,
Then clamp it up and weld the lip back on.
Didn't grind too much meat off the weld to make pretty and thin here since it ends up with about a quarter inch of brush sealer over it. Lines up nice now, should be able to hang the quarter on now and see what issues it will have.
Dealing with this pain in the butt gap took quite a bit more time then I thought it would.
Decided I had to cut the lip off and section in some steel then cut that off back to where the lip would then line up,
Then clamp it up and weld the lip back on.
Didn't grind too much meat off the weld to make pretty and thin here since it ends up with about a quarter inch of brush sealer over it. Lines up nice now, should be able to hang the quarter on now and see what issues it will have.
