casting# block 2202857-7 & intake 4104595 yr??

Just a note of caution, be aware that the OE crank in an engine of that era
would've had the smaller rear hub dia., and would also have had a pushbutton trans
if it were an auto. Not likely your car has that swapped in,so there's a good chance
the block was used for a build to replace the orig. eng. & had the '68 and up crank
installed. One would've had to change the torque converter,input shaft/frt. drum,frt.
pump,& flexplate to make you're trans accommodate the smaller crank end(unlikely).