Anyone out there use a nitrous six pack set up?

It is a nos brand set up.. It uses a spray bar plate under the outboard carbs and the center carb is just a spacer. It uses one fuel and one nitrous solenoid teed to run both plates.

I just had it out for another ride and I bent the micro switch so it would come on a bit sooner, right under 3/4 of the travel for the outboard carbs(also limits the carbs from opening anymore).. The micro switch trips right around 3000 rpm and stays on until I shift each gear.

So at 3000 rpm the outboard car travel is right under 3/4. I think I am going to put a micro switch with a 2 inch lever and lower the bracket. It should trip the same way it is setup now but the lever should bow some to let the carbs finish there travel. Basically working like accelerator pump as you stated. Allow nitrous to come on a bit earlier and run through