Control arm camber bolt washer play Help Plz.

This is a common occurrence if you installed new bolts.I ran into this many times during my years in an alignment shop.
The flats on the bolt are not cut up the shank far enough, and when you torque it up,you think it's tight, but it hasn't put enough squeeze on it yet;you just bottomed the special washer on the flats
My solution was to install an extra hardened washer or two.One has to go on the HH side,right under the head; eg, first item on. This pulls the flats further away from the special washer on the other side, usually providing enough squeeze room.Sometimes it took two.
I think I used teener head bolt washers
Problem solved!