Holy Roller
Well-Known Member
Is the square bar inside the rear seat that operates the side latches supposed to be straight from end to end. Or is it supposed to be bent at the ends? Your help is greatly appreciated
Rear seat question
- Thread starter Holy Roller
- Start date
-
What kind of car are you talking about? And what latch are you talking about?
Holy Roller
Well-Known Member
68 barracuda fastback, it's the latch on yhe side of the seat to fold down the seat.
I have a 68 I'm building now. Can you take a picture of it and I can compare it to my seat.
Holy Roller
Well-Known Member
Ok, I'll get one tomorrow and upload it.
Holy Roller
Well-Known Member
Roy, I haven't forgotten about the pics. I started a turnaround and haven't had a chance to get the pics. I have some on my phone, but i can't upload them on here. I'll get them as soon as i can.
Ok----Roy
Yote
Well-Known Member
Oops, thought this thread was going to be racy and bring back old memories.
Yote
Yote
I'm pretty sure it is supposed to be dead straight. The square ends fit into the cams that operate the latch. But my FB is off the premises so I can't take pictures.
Holy Roller
Well-Known Member
Holy Roller
Well-Known Member
I think your right, mine is bent at both ends...but not in the same direction. So I may end up replacing it, as soon as I can I'll post some pics to get a better idea. Thank you
norshorblufish
By the Big Water
This might help.
Last edited:
norshorblufish
By the Big Water
This might help.
norshorblufish
By the Big Water
sorry about the first one. Still getting acquainted with the new format. So far I like it though.
Holy Roller
Well-Known Member
Yeah, it kind of grows on you. I wished you could upload pics from your phone gallery though.
Holy Roller
Well-Known Member
The diagram does show the rod to be straight..doesn't it. Thank you for that, it helped a lot.
-
