3 point Lakewood help

Hi,
I want to make and install an old school 3 point Lakewood Roll Bar in my ´68 Barracuda, and want it to look period correct for the late sixties racers.
Question: was this post in a vertical position?
I would like the loop to be a little more in line with the center of the seat. This can be achieved by leaning this post slightly inwards, but only if this was how it was done.
This tubing is not of correct dimension, but this is not an issue yet...
Your help is much appreciated.
And sun is shining
Thanks, Stefan

Very cool project! Even cooler that your in Sweden! I Googled Lakewood roll bar awhile back and there were several pics of the roll bars and a group of guy's called Weekend Warrior Garage or something like that and they were going to start reproducing the roll bar. I believe they had a camaro they fitting it to but they may have the dimensions you may need. Good luck! Keep updating with your progress.

Riff Raff said:

Very cool project! Even cooler that your in Sweden! I Googled Lakewood roll bar awhile back and there were several pics of the roll bars and a group of guy's called Weekend Warrior Garage or something like that and they were going to start reproducing the roll bar. I believe they had a camaro they fitting it to but they may have the dimensions you may need. Good luck! Keep updating with your progress.

Click to expand...

Yes thanks,
I have been on their site too, and yes, a lot of nice pic, but still it´s hard to tell the specific issue I need to clear out...
I think I need help from someone with the same model as mine, since Lakewood offered a number of different sets for different applications.

Question:
Did the Lakewood 3 point Roll Bar for Mopar A-Body, have the rear bar directed towards were the Snubber meet the flor pan. On GM Cars I think this bar meet the left front spring hanger?