Milodon 31000, anyone have it?

Map63Vette said
Is that just the regular mid sump A body swap pan? If it is then that's what I have on my 67 Dart. Started with an aluminum fabbed pan that my dad found on Ebay, but the pan rail welds cracked and leaked oil all over the place. Went with the Milodon because it was steel and have had no problems since, though I'm using the stock pan gasket/windage tray, not the Milodon one. Why did Realwing say to avoid it?

Yes, milodon's standard mid-sump catch-all. Realwing referred me to this thread... didn't specifically say avoid it, my words.

toplscuda said
Ok pics are hard to get but this should give you an idea on the truck pan. Above the rack there is still about 3/8" of clearance between the rack and the pan. The lowest part of the pan (drain plug) is about 7 3/4" below the pan rail on the block.

Thanks man, I think I'm gonna go that route, cost is the biggest factor right now in this build so the cheap truck pan is probably my safest bet.