Another Thermostat / Housing question.
I originally purchased this neck and this T-Stat for my SB. It came as a kit.
Mopar Performance P4286759: Chrome Thermostat Housing Fits All Slant Six, Small-Block, Big-Block & HEMI Engines 1978 & Prior | JEGS
Mr Gasket 4367: Hi-Flow Thermostat Chrysler, Dodge | JEGS
I drove the car twice and on the 2nd run the T-Stat wouldn't open. So I pulled it.
I then went and purchased this T-Stat for my SB.
https://www.summitracing.com/parts/snn-45358
The T-Stat sits fine in my Edelbrock Performer intake manifold.
Could be a tad wider but none the less it fits.
The problem I am having is the housing I now have has a has like a groove that isn't allowing the housing to push again the T stat and hold it in place.
When I put the T-stat down on top of the intake the T-stat moves around in there.
Now here is my question:
Will this housing (link below) work with the T-Stat I have? There is no pics of the under side of the housing for me to judge it. Just looking if anyone else has any experience with it.
https://www.summitracing.com/parts/bsp-90820/overview/
In the end I just want a housing and 180 t-stat that works without spending $100 for a housing.
Thank you in advance.
I originally purchased this neck and this T-Stat for my SB. It came as a kit.
Mopar Performance P4286759: Chrome Thermostat Housing Fits All Slant Six, Small-Block, Big-Block & HEMI Engines 1978 & Prior | JEGS
Mr Gasket 4367: Hi-Flow Thermostat Chrysler, Dodge | JEGS
I drove the car twice and on the 2nd run the T-Stat wouldn't open. So I pulled it.
I then went and purchased this T-Stat for my SB.
https://www.summitracing.com/parts/snn-45358
The T-Stat sits fine in my Edelbrock Performer intake manifold.
Could be a tad wider but none the less it fits.
The problem I am having is the housing I now have has a has like a groove that isn't allowing the housing to push again the T stat and hold it in place.
When I put the T-stat down on top of the intake the T-stat moves around in there.
Now here is my question:
Will this housing (link below) work with the T-Stat I have? There is no pics of the under side of the housing for me to judge it. Just looking if anyone else has any experience with it.
https://www.summitracing.com/parts/bsp-90820/overview/
In the end I just want a housing and 180 t-stat that works without spending $100 for a housing.
Thank you in advance.
