Rocker Geometry!
We had these rockers made to our spec with proper shaft placement in mind. It cleaned up the geometry all around.
More pics.
Top shot. Don't worry, T&D didn't have the right length center studs for our needs, so bolts were used for mock up. Studs are ordered.
Here is the sweep pattern. With .708" net lift, the sweep is a paltry .044" wide. That's some excellent valvetrain efficiency right there.
I don't foresee any more broken pushrods, especially since we stepped up to a 7/16"×.120" wall for the 800# open spring pressures.
Btw, we have a 505 with Trick Flows in the shop as well. These rockers have excellent geometry on them also.
We had these rockers made to our spec with proper shaft placement in mind. It cleaned up the geometry all around.
More pics.
Top shot. Don't worry, T&D didn't have the right length center studs for our needs, so bolts were used for mock up. Studs are ordered.
Here is the sweep pattern. With .708" net lift, the sweep is a paltry .044" wide. That's some excellent valvetrain efficiency right there.
I don't foresee any more broken pushrods, especially since we stepped up to a 7/16"×.120" wall for the 800# open spring pressures.
Btw, we have a 505 with Trick Flows in the shop as well. These rockers have excellent geometry on them also.
