Head quest

All the work to get any head into this zone , yet still chained with stock constraints.
Spend 1500 on just eddy heads, then 1000+ more on port work and more $ to redo the valve job and guides anyhow.

W2.
Or if you're crazy , bored or like to be odd take some easy 360 heads, tube the head bolt holes between intake ports, tube oil feed to rocker stand, epoxy washers into bolt recesses, die thread some mild steel round stock, tap the push rod holes....screw them mild steel stock in with epoxy or red loctite....then Bridgeport some reliefs for the offset rockers, hard seat all int/exh, vmve job, BP guides to half their height .....and of course port the **** out of them, but...oh wait, that's exactly how they came up with the W2 prototype....isn't it.
They just can't seem to do much better with these blocks, they are always only a hop or a skip away from a old iron 360 head.
It's all been done. You see the ceiling? Its right there...