Adding Delay Windshield Wipers
Zoom
WINDSHIELD WIPER TIMER MODULE
Time interval (without modifications) is adjustable from 3 to 30 seconds for intermittent wiper function.
Fully Assembled Module
$10.00
SKU:MXA041
Qty:
Email to a Friend
Chose a knob for the potentiometer here: HARDWARE <-- We include a small plastic knob with the MXA041 now.
Keep in mind that there are far to many wiring configurations for us to be able help with all installs.
Knowledge of automotive wiring is required for successful installation.
Basically this is just like a switch that goes across the low speed switch.
The easiest way to make the unit work is, locate which wire is the slow speed wipe.
Connect a lead to your positive terminal on your battery and the other end is used to probe the wiper motor wires.
Which ever one starts the slow wipe cycle is the one you are after.
Now connect the COM pin of the relay to positve of your cars supply, the NO pin goes to the wire you have just discovered.
The wipe cycle should complete a full revolution when you remove the trigger wire (your positive probe).
Zoom
WINDSHIELD WIPER TIMER MODULE
Time interval (without modifications) is adjustable from 3 to 30 seconds for intermittent wiper function.
Fully Assembled Module
SKU:MXA041
- Buy 5 for $9.50 each and save 5%
- Buy 10 for $9.00 each and save 10%
- Buy 50 for $8.50 each and save 15%
Qty:
Email to a Friend
- Enclosures
- The pot has an ON/OFF switch incorporated and it would be possible to add a short length of wire (100 cm or aprox 36 inchs 5 wires in total) to remotely mount the control.
Chose a knob for the potentiometer here: HARDWARE <-- We include a small plastic knob with the MXA041 now.
Keep in mind that there are far to many wiring configurations for us to be able help with all installs.
Knowledge of automotive wiring is required for successful installation.
Basically this is just like a switch that goes across the low speed switch.
The easiest way to make the unit work is, locate which wire is the slow speed wipe.
Connect a lead to your positive terminal on your battery and the other end is used to probe the wiper motor wires.
Which ever one starts the slow wipe cycle is the one you are after.
Now connect the COM pin of the relay to positve of your cars supply, the NO pin goes to the wire you have just discovered.
The wipe cycle should complete a full revolution when you remove the trigger wire (your positive probe).
- I used an old door window crank nob to match my other door crank nobs, drilled it and tapped for a set screw, inserted delay unit in a lower dash gauge panel below my a/c ducts
