[WANTED] 1967 Barracuda Trunk Script

-
Status
Not open for further replies.
M

MICHAEL J KLOCK

Well-Known Member
Joined
Jun 11, 2017
Messages
152
Reaction score
61
Location
nj
Rating - 0%
0   0   0
Contact seller
Hello!
I'm looking for a super clean Barracuda logo for the right side of my trunk lid.
NOS would be better! Apparently nobody is reproducing these emblems.
IMG_4464.JPG

Thanks in advance in you can help!
 
How that badge was attached to the finish panel is/was pretty much a one time deal. A used one would likely need to be glued on. I suppose the aftermarket could make them with studs and nuts like the 68 script and most every other badge has. Expecting the buyer to drill holes through their trunk lid? I doubt it. Good luck
 
RedFish said:
How that badge was attached to the finish panel is/was pretty much a one time deal. A used one would likely need to be glued on. I suppose the aftermarket could make them with studs and nuts like the 68 script and most every other badge has. Expecting the buyer to drill holes through their trunk lid? I doubt it. Good luck
Click to expand...
The previous owner glued it on with JB weld, it's not totally screwed up but has lots of small damage. I figure I can either use a fender script with is just a bit smaller, or send this one out to Pauls Chrome in PA. $$$$$$$$$$$$$$$$$$
 
Might have several decent ones. Let me check. How many studs are they supposed to have??
 
MICHAEL J KLOCK said:
Hello!
I'm looking for a super clean Barracuda logo for the right side of my trunk lid.
NOS would be better! Apparently nobody is reproducing these emblems.View attachment 1715084902
Thanks in advance in you can help!
Click to expand...
This emblem is the same as the fender emblem for a '65 Barracuda. (I believe). I bought a pair from Firestone Collectibles. One of them is an exact match and the other requires an additional hole. Hope this helps. Scott.
 
What is the overall length and what is the length between studs? I'd ask for a PN but don't know where my magnifying glass is and I'm blind as a bat.
 
GTXperience said:
What is the overall length and what is the length between studs? I'd ask for a PN but don't know where my magnifying glass is and I'm blind as a bat.
Click to expand...

No worries, I spoke with Jason at Paul's Chrome in PA this morning. They will re chrome my script and replace all the broken mounting studs for me. I'm shipping mine out next week.
 
MICHAEL J KLOCK said:
No worries, I spoke with Jason at Paul's Chrome in PA this morning. They will re chrome my script and replace all the broken mounting studs for me. I'm shipping mine out next week.
Click to expand...

Just got back from spending my lunchtime at storage and believe I find a very nice one but the studs are broken off.
 
The anchors on this particular badge... Maybe we could call them brads? They're not the same studs found on other badges. A cast brad with a 0 to 1/16 grip range is more correct.
 
Status
Not open for further replies.
-

Back
Top