440/4 speed install, which method?
Hey question: probably a dumb one.
Number 1 piston ATDC on compression stroke and the rotor points to just before the number 1 lead on the dizzy cap.
See pic. And my pointer.
Should I move my leads so number 1 was where number 2 was or to where number 8 is or just leave it there and play with the advance??
Got 65psi oil pressure,
Got spark. At coil lead. Will check at plug end.
Got fuel
New battery
New starter
New plugs
A couple of pumps and she is firing (wants to start) but not enough to run.
Hey question: probably a dumb one.
Number 1 piston ATDC on compression stroke and the rotor points to just before the number 1 lead on the dizzy cap.
See pic. And my pointer.
Should I move my leads so number 1 was where number 2 was or to where number 8 is or just leave it there and play with the advance??
Got 65psi oil pressure,
Got spark. At coil lead. Will check at plug end.
Got fuel
New battery
New starter
New plugs
A couple of pumps and she is firing (wants to start) but not enough to run.
