67 GT trunk panel mounting

67 gt said
Locumob no panel has 4 small self taper screws to hold it in place & the trim pieces run on different holes they have like a wave clip which is held in place via a speed nut from inside the lid easy access with 1/4 inch drive socket . Here's some pics of the lid which shows the hole locations from when I had the rear trim off. Note* small holes are for the panel , holes top and bottom is where the 4 trim pieces mount. Those 4 holes near the lock I don't know what went in there unless there was a badge in there at some point ???

View attachment 1715102672

View attachment 1715102673

View attachment 1715102674

View attachment 1715102679

View attachment 1715102680

That's what I've been looking for! Kinda hard to see where it mounts when the only examples are already on the car. Do you have a source for the clips for the trim pieces? I have a few of the wavy clips but not sure how many I need and would prefer new.

Those holes look like where the letters went, speeding out "DODGE". That what they are on my trunk.