Another clutch not completely disengaging thread

hey all, i have fitted a Powertrain Technology hydraulic bearing to my a833, pedal feels great, master cyl appears to be getting full travel (1.25" stroke), hyd bearing seems to be working ok but it still wont fully disengage the clutch, with pedal in the "up" position, the bearing is practically touching the pressure plate fingers (diaphragm type). I can force it into reverse, 3rd, and 4th gears, 1st and 2nd are a no go, when in gear though, releasing the pedal to make the car move feels like its all working fine, starts to move roughly about 1/3 travel off the floor, also i have bled the hell out of it, with someone working the pedal it bled well, and i also tried gravity bleed, but doing that, seems like its full of air! And i could bleed it for hours and the air bubbles just keep coming.
So basically i just need the hydraulic throwout bearing to travel just that little bit more to completely disengage the clutch, everything else seems to be ok, its all thats stopping me from driving my car!
Any advice would be greatly appreciated thanks.

20171115_165204.jpg

20171115_175354.jpg

20171115_175400.jpg