How to remove PS box

LOL - funny you mentioned the pickle fork. I was using a small crowbar and although I didn't scratch anything, it occured to me that I might do some damage if I wasn't careful. I happened to have a pickle fork right there and it fit perfectly.

I separated the input shaft, got the last bolt on the box out, while inserting an allen wrench into one of the bolt holes to keep the box from dropping. Then after wiggling it around a bit, couldn't figure out where it was bound up - the allen wrench, of course. LOL

Now the rain's coming down pretty good, so I think I'm done for a bit. Just a sanity check here, but I should be pulling the box up and out rather than down and under, correct? Leaving the pitman arm on there is making it more of a challenge to pull it out, but hopefully it's not a showstopper. I know they sell the box with the arm attached, so it must fit in there with or without.