How to remove PS box

A couple updates - been sick this week, so slow progress.

I got the bushing from Summit and it seems a perfect fit for the pitman arm. Managed to get all the seals off the sector shaft. The dust seal was easy to remove, snap ring was a little tricky, and then I used a technique from another member to remove the main seal (2 #6 wood screws - still took some muscle and a good pair of pliers to pull it out). There was a washer inside the snap ring, and I thought at first that it was the inner seal until my drill bit was taking forever to go through it (doh!). Fortunately, damage to it was minimal and I should be able to reuse it.

The sector shaft has no wiggle to it at all, which is a good sign.

Question: The input shaft has some play (maybe a 1mm or less left to right) - is this normal or do I need to take the rest of box apart?

I should be able to get all the seals back in tomorrow and paint it, and with any luck install it before the end of the weekend. Worst case, I'll have the Scamp back on the road next weekend.

-John