Lower control arms help needed.

I just pressed the pin out with a ball joint press. The Pull the rubber bushing out with a pliers
Then welded a bolt in the bushing case and drove it out with a longer bolt on the back side of the control arm. Then the pin will have a sleeve on it you have to remove as well. For that I just chucked it in my vice and took an air chisel (a hammer and chisel will work too if you dont have an air chisel)
And every 90 degrees around the diameter of the sleeve I hammers a line straight down the length of the sleeve. Then took it out if the vice and it slid off with pliers.
I have some pics if you need them.