Here is a Abody spindle left and a b body spindle right... I’m running a small ball joint qa1 on a big ball joint b body spindle with a adapter. The 52301 I ordered does have different geometry at the ball joint end to hold the bigger ball joint and sits slightly differently on the spindle then the incorrect 52303 small ball joint arm made for a 70-72 Abody small ball joint spindle. Look at the difference in the spindles at the ball joint end. Clearly different geometry there or am I blind? The cam adjuster on the arm is maxed right out completely there’s literally no more travel past the .5 negative camber which is not right. We are talking like a degree off to get me into positive if I wanted. I’m confident bolting that 52301 arm which is correct for the spindle I’m running will give that change. If it doesn’t then I’m wrong.... also everywhere I read about these goofy adapters for the ball joints most people are complaining about them. It very well could be a k memeber slightly off during install, a slightly rolled frame or a adjustment off somewhere else but doubt that as the control arm literally has no more travel it’s fully extended and cannot be adjusted further no matter what I do to the castor or ride height or anything else. Wrong arm and wrong ball joint is where I’m starting this mess as I don’t want a small ball joint in a big ball joint spindle. I’ll go from there and see what happens.
View attachment 1715372269