Stroker 340>416 Build Advice

Psychobob22 said

Thanks for the response so far! To answer some of the questions:
Weight of the car is unknown but Id imagine pretty close to stock as not a whole lot has been done to customize it.
Gearing right now it has a sure grip 3.73 741 case which I want to get a 742/489 case with probably 3.55 to get closer to highway speeds at not a ridiculous rpm and make it stronger for the higher hp engine.
Elevation is between 1kft-3.5kft
As for hp after reading other posts Id be happy with 450-500hp I dont really intend on dragging much or doing cannonball runs haha

Click to expand...

Do you need vacuum to operated power brakes?

What's your carb tuning skills? Like do you prefer a cam nice vacuum signal?

Do you want an hydraulic cam? Solid, Roller?

This will not see any regular drag strip time? Just a street cruiser something you could drive from Tucson to Phoenix in? ~100 hwy miles

What is your rear tire size (diameter)?

Do you home pocket port your own heads? Or would that be something you'd hire out? Could you take apart a set of heads to inspect them and reassemble?

Are you assembling this motor or paying someone else?