68/9 barracuda windshield stainless clips
Ok so I'm marking up where the sides and top clips go. Due to the short lip/ledge on tops/sides, the clip has to sit down as deep as it can go. I marked the holes with marker and measured from bottom to center of hole is approx .177". Sound about right?
Drill bit size?
Ok so I'm marking up where the sides and top clips go. Due to the short lip/ledge on tops/sides, the clip has to sit down as deep as it can go. I marked the holes with marker and measured from bottom to center of hole is approx .177". Sound about right?
Drill bit size?