Front end setup (Drag Racing)

Ok, this was a good read. My build is finally ready for a front end alignment and I have one scheduled for next Friday.

Front setup - QA1 k-member, QA1 upper and lower control arms, QA1 strut rods, Factory /6 torsion bars, Calvert 90/10's.
Rear setup - Inboarded Calvert Split mono leafs, Caltracs with springs set to 1" lower, Calvert sliders, Calvert adjustable shocks, Pinion angle set to 4 degrees down.

Here's what I have decided to use for specs.

0 - Camber
5 degrees Caster
1/16" toe in although I am kinda 2nd guessing this one.

We will be checking rear axle alignment as well as making any adjustments to the k-member prior to final alignment.

Any feedback and or suggestions?

Thanks, Bill