SBM Milodon gear drive
(Pictured below)
I haven’t even read the instructions to it. I did the obvious and stopped to ask the question above.
I’ll have to agree. I think the oil slinger is out. Everything is a bit tight for the slinger, *I Think* anyway. To the point I’m not going to bother, but I’ll try because you asked. Maybe????? It’ll squeeze in behind the gear. Here is a back side of the gear shot for you.
IMO, as I see it, if the slinger can be installed, it’s just dripping oil on the back side of the gear. Which is solid. The holes in the sprocket would allow oil out but it would be to nowhere up front.
Jeff, I’m working on a small block. I don’t know how much of this transfers over to a big block. I just took this out of the wrapper & have done nothing more than get this far.
(Pictured below)
I haven’t even read the instructions to it. I did the obvious and stopped to ask the question above.
I’ll have to agree. I think the oil slinger is out. Everything is a bit tight for the slinger, *I Think* anyway. To the point I’m not going to bother, but I’ll try because you asked. Maybe????? It’ll squeeze in behind the gear. Here is a back side of the gear shot for you.
IMO, as I see it, if the slinger can be installed, it’s just dripping oil on the back side of the gear. Which is solid. The holes in the sprocket would allow oil out but it would be to nowhere up front.
