TF & Speedmaster Flow Tests

I wonder if……..
One were to rework one of the SM ports to a lesser extent than what’s been tested so far, concentrating primarily on getting SSR area sorted out so that it would allow the flow to show increases past .600 lift…….even if the flow capacity at those lifts is below the current 285cfm level.
Say you got [email protected]……….would the flow in the areas(6 o’clock, etc) where it’s next to nothing now……..still be next to nothing?

At the other end of the spectrum, I wonder how one of PBR’s non-stalling 300+ cfm SM’s would compare with that test.