Starting my Early-A Conversion to disc
The one you have attached for the passenger side, I slid the bending spring down to the fitting and bent it between 60° and 90° to go in thru the side, it the noutes to the firewall and back up to go around the engime. The short driver side line out the front, because I didn't think it would reach with a added bend to it.
Hard to get a good pic with the torque shaft in the way.
It clears the Y pipe by about 1-1/2". So I left the spring lower to help with heat dissipation
The one you have attached for the passenger side, I slid the bending spring down to the fitting and bent it between 60° and 90° to go in thru the side, it the noutes to the firewall and back up to go around the engime. The short driver side line out the front, because I didn't think it would reach with a added bend to it.
Hard to get a good pic with the torque shaft in the way.
It clears the Y pipe by about 1-1/2". So I left the spring lower to help with heat dissipation