70 dart 470 ci drag car build.
I went outside after work last night and checked my pattern with some Prussian blue this time.
The pinion was just a tad too deep. I ended up taking some shim out behind the pinion and added some to the passenger side of the carrier that also put me in spec with the backlash.
I really must thank @73smallblock thanks dude for helping me dial it in. I sent him a few pictures and asked is it good or not ?
Here's a picture of its final location and now I can assemble it.
I am going to drill and tap a drain plug in the bottom of the housing and relocate my vent, maybe put a vent on each axle tube.
I went outside after work last night and checked my pattern with some Prussian blue this time.
The pinion was just a tad too deep. I ended up taking some shim out behind the pinion and added some to the passenger side of the carrier that also put me in spec with the backlash.
I really must thank @73smallblock thanks dude for helping me dial it in. I sent him a few pictures and asked is it good or not ?
Here's a picture of its final location and now I can assemble it.
I am going to drill and tap a drain plug in the bottom of the housing and relocate my vent, maybe put a vent on each axle tube.
