dash wiring help please part II

I have an update to my problem. I have since hooked up the whole system, added a ground to the steering column and tested the turn signal switch. I found the switch to be faulty and bought a new switch and hooked it up. (not installed in steering column yet) I turned on the hazzard lights and yahoooo, I've got 4-ways!! I used a 20 amp circuit breaker w/ alligator clips and used it in place of the fuse for my turn signal/heater blower motor/? location on the fuse box. I turned on the ignition and turned on the signal and I had turn signals both ways! I think I turned off the inition switch and turned it back on to test the heater motor again. I do know that I turned on the heater blower motor and it ram fine. somewhere along the way it ended up that my original problem of the signals not working and the signal flasher clicking when the ignition is on even when the signal is off. I disconnected the heater blower motor switch and tried it again but the clicking and no signal lights continued to be a problem. I do not remember if any of this happened because of depressing the brake but I don't think so. (it has been over a week since). What gives? :dontknow:

BTW, I do not think the under dash harness is incorrect as it is pretty consistant w/ the wiring diagram other than some of the fuse box (and no schematic I have looked at from 72-73 has matched up very well):dontknow:
:dontknow:


:dontknow: