Search results for query: *

have a 71-73 am/fm radio for sale. tested and working, no cut plugs, part numbers are still visible on sticker...price is $500 shipped in lower 48.

explorer 8.8 rear end. factory disc brake, 4.10 gear ratio with trac-loc posi. 31 spline axles. has had the drivers side tube narrowed 3 inches, new axle shaft. has new spring perches welded on at 43 inch centers for A-body. axle is 57.250 wheel mounting surface to wheel mounting surface. comes...

reduced how about $2500 OBO...

Notarized bill of sale is all that is required in the state of KY. But, doing too many lost/classic car titles, will throw up red flags. Usually, everyone wants "someone else" to do the leg work/time/hassle of getting the title for them,...and sell them the car for the same price. So, a person...

1973 plymouth scamp project. factory 318/904 auto car, factory a/c, power steering and power disc brakes. story from original owners family is the mileage is correct at 37K miles. car sat in a very damp and leaky barn for many years. not a bad body, typical a-body rust, trunk floor gone, lower...

rear end is 2.94 geared open. has 10 X 2 1/2" brakes. comes complete drum to drum in a 37K original mile car. still in car so you can check it out before it's pulled. does NOT come with sock plates, nor are they for sale. i am selling the 318/904 out of this car, but, NO other parts of the car...

1973 model 318 engine and 904 automatic transmission in a plymouth scamp. stone stock, car has 37,*** miles. car sat for many years until recently. starts runs and pulls as it should. no smoke, noises, etc. still in the car so you can check it all out before you pull it. does NOT include...

none that i can see

i fick it..sorry, brainfart...

i have a good, used, ready to use or for build-ups, 8 3/4 chrysler 3rd-member hoghead. its a "489" case, 3.23 gears with sure-grip and large yoke. price is $700 plus the shipping. i am located in henderson,ky 42420 thanks for looking

i have a vintage DP4B aluminum edelbrock 4 barrel intake for 383-400 low-deck. clean, flat, has been mounted and ran in the past. no striped carb stud holes, no heli-coils. look at the pics, ask questions. $200 plus the ride

small block aluminum edelbrock vintage LD4B 4 barrel intake in great shape, been on the shelf for years. one of the best small mopar intakes made for street duty. clean and flat, no stripped carb stud holes, no heli-coils $300. plus the ride

i have a brand new in the box, only removed for pics, Mopar M1 single plane intake for small block chrysler. been on the shelf for year. pat #4532851. great street ir strip intake. even comes with the fel-pro intake gaskets from mopar performance. $300 plus the ride

1996 ford F450 superduty rollback tow truck. 7.3 powerstroke diesel engine. 5 speed manual transmission with PTO, disc brakes all around. a/c, heat, power windows, locks, steering and brakes, tilt and cruise. 217K miles, new clutch and solid flywheel at 195K miles, front tires are yokohama...

have a set of 340 pistons and rods. they were removed from a 71 model 340, standard bore, 4-valve relief, "645" rods. clean skirts, 7 pistons are original, 1 is an aftermarket with a broken skirt. price is $100 plus shipping. thanks

fixed it

more pics

had a small block in it. yes, have other header,....PM with needs and for prices.....

ad reads to tell what is there and what all i have. message me for prices and needs.

more

more

more

more pics

PARTING OUT, NOT SELLING WHOLE CAR, UNLESS YOU PLAN ON ACTUALLY PAYING FOR IT......1971 plymouth duster project. was factory slant 6/auto car, still has the slant 6 "K" frame with schumacher SB mounts and small block hedman headers. also comes with a 72 and older V8 "K" frame with sway bar...

2006 dodge dakota club-cab 4x4 pickup. this is a very low production. 4.7 H.O magnum V8 (2nd generation 4.7) , 5-speed "hemi spec" 545 RFE automatic transmission, 3.91 geared heavy-duty 9 1/4" sure-grip rear axle. 98K original miles, new tires less than 1000 miles mounted on the R/T chrome-clad...

1972, model removed from a 37,*** mile B300 1-ton maxi-van. drove when pulled includes stock torque converter. been stored in a dry pole barn for 5 years. $350 obo.

1972 model industrial red 318 engine. stone stock, removed from a 37,*** mile dodge 1-ton maxi-van. turns over easily by hand. everything is here except air cleaner, wp pulley and fan. been kept inside poll barn storage for 5 years. look at the pics, ask questions. $250 .message here

price reduced $1250 or make offer

1967, removed from a 47,*** mile imperial. drove when pulled, includes stock torque converter. been stored in a dry polebarn over 20 years. $250. can ship fastenal 3PL. go online and get a free quote, 40"X48" pallet, #150. PM here. thanks for looking