Search results for query: *

Rusty, point taken, thank you. RR

I will check utube again. who sells the diodes?

OK I will wire it back. thank you. RR

70's squareback. can I rebuild this at home & if so what areas do I attack? I have one that O'reillys says is only putting out a few volts iirc. O'reillys has a pulley puller if needed. thank you for your time. RR

63 dart 360/904/5:57 stock car. it will be cruising a bit in 3rd before they drop the green flag. should I wire it all the way back or get the mechanical kickdown linkage that applies it gradually as you give it throttle? thank you for your time. RR

with all the good info here I feel confident. RR

I do have some extra packing tape & no plans to box anything up & use it

I will price that press and get a quote from a shop & go from there. RR

good info guys, I'm gonna give her hell. RR

You're fine John & very much appreciated. RR

good comprehensive info & very much appreciated. I think I will confirm the TDC slit then glue the sh-t out of it & for backup scribe the marks on the side using it as a ruler. RR

good comprehensive info, much appreciated! RR

OK I will take it in, thanks a bunch guys. RR

new BBP A body 8&3/4 axles/tapered bearings/lock collar. can I assemble all this myself or do I need to take em in to a shop? thank you for your time. RR

I had prior thought about just useing it as a ruler with a paint stick as I only need a few measurements (initial/total & a few numbers on either side of that} but I am going to glue the hell out of this one. RR

thanks 67, will do

what should I use to lock it on the dampener so it stays put? thank you for your time. RR

PM sent

I will take one. EDIT your inbox is full

do you have a company address/phone for him? I have a set of schumaker mts & I need some info.

PM sent

Oh My God! bro that would certainly explain the drastic tilt that I have, thank you! RR

Much appreciated! & I stumbled onto my avatar! RR

pic on right. Mike where exactly is my avatar at, I way behind on this stuff

I posted this before & someone posted a link to a company that sells em but I lost it. anyone know who sells em? thank you for your time. RR

^^^ I will do that. here's pics of the mounts

what I had to do is set the mounts/biscuits on/in the kmember hole(s) then lower the eng the rest of the way slightly until the ears were close to the mounts then raise the mounts slightly to meet the ears & bolt them up to the ears making sure the lower stud(s) stayed in the kmember slot(s)...

as they say a pic is worth a thousand words. Much appreciated. RR

63 dart 360. (273 64-66 V8 mts). On which side(s) do the tall/short ones go? I am way too high on the pass side (508 rubber insulators both sides). maybe I have the eng off sideways with the mtr mt slotted hole(s) in the kmember allowing alot of leeway for positioning side to side. thank you for...

Professor when I get out there I will see if anything seems wonky and I will ask for their best ones. RR