Search results for query: *

  1. 71DodgeDemon340

    [SOLD] Taylor Cable Thundervolt 8.2mm Plug Wires With Coil Wire, Cap & Rotor, Wire Separators And 90 Degree Boot/Terminal Kit For Small Block

    Up for sale i have a nice little package. I have a set of lightly used Taylor Thundervolt 8.2mm spark plug wires with coil wire, Taylor Cable distributor cap & rotor, 90 degree distributor terminal kit, 90 degree distributor boot kit and a pack of Taylor Cable spark plug wire separators. The...
  2. 71DodgeDemon340

    Any source on replacement gasket for 71 gas cap?

    Does the vent ever go bad? I checked it and it appears to be working correctly, it is allowing air to be sucked through the vent hole and the valve closes when you try to blow through it
  3. 71DodgeDemon340

    Any source on replacement gasket for 71 gas cap?

    Thanks everyone for the suggestions, i crossed over that gates number 31743 provided by @66Valiant528 to a stant 10800 cap from oreillys. We get a little bit of a price break from oreillys through my work so i ordered one with my cost being $10. The gasket swapped over perfectly although the...
  4. 71DodgeDemon340

    Any source on replacement gasket for 71 gas cap?

    Is the gasket the same dimensions between vented and non vented?
  5. 71DodgeDemon340

    Any source on replacement gasket for 71 gas cap?

    Just any stant cap for a a body? Is the diameter the same for all the years?
  6. 71DodgeDemon340

    Any source on replacement gasket for 71 gas cap?

    Hey everyone the gasket on my 71 gas cap is shot, any good recommendations for a replacement? I have seen where some have said the gasket from a early mustang cap will work but havent seen anything specifically about a replacement for the 71 cap
  7. 71DodgeDemon340

    What Are You Doing To/With Your Car Today?

    Got the right bank done as well as fresh plugs all the way around. The HEI terminals look so much cleaner
  8. 71DodgeDemon340

    What Are You Doing To/With Your Car Today?

    Yeah i didnt mind the stock appearance of the straight plug wires but i figure wouldnt hurt to clean it up some, its so tight back there the straight wires are all over the place lol. Also dont mind my #1 being off one terminal, iirc the distributor i had originally put in had to be clocked that...
  9. 71DodgeDemon340

    What Are You Doing To/With Your Car Today?

    Was tired of having the straight plug wires going into the distributor, i had the taylor thundervolt wires that were pre made but there was excessive slack and the plug wires would stick up above the air cleaner. Made the swap from the female socket distributor cap to the Summit Racing HEI style...
  10. 71DodgeDemon340

    Best cap and rotor for factory style electronic distributor?

    I just ordered this cap and rotor kit from summit, im putting new moroso ultra 40 wires on and they have to be cut to length so i figured might as well update the cap to the more secure hei style. I know a few on here have used them and all positive reviews on summit Summit Racing SUM-G5239...
  11. 71DodgeDemon340

    Best cap and rotor for factory style electronic distributor?

    Sorry lol i thought about that after i posted, i updated the thread
  12. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    I will try to cut a couple of the spark plugs to see if i can get you guys more info, 5 of the plugs are a touch black mid way down the porcelain but cylinder 7 and 8 look the same and the porcelain is pretty uniform as deep as i can see
  13. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    So should i leave the heat range plug i have in it now and adjust the idle mixture a little leaner? The plugs look white in the photo because of the flash, they are a very light tan/gray in natural light, ill see if i can get some pics of them outside maybe they will show up more true
  14. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    So why the drastic change going from 93 non ethanol pump gas to 96 vp non oxygenated race fuel? Before on 93 the porcelain was black
  15. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    Ok trail beast says too much timing and too hot of a plug, you say not enough timing and too cold of a plug. Lol
  16. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    I thank everyone in advance for their time and input
  17. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    Thanks for the advice, you are talking about initial timing correct? Also would you recommend i try one range colder?
  18. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    Cant remember what vacuum, and as far as i know the factory step up springs are installed
  19. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    Are you referring to initial or total timing by that mark? Is the initial timing closer to the end of the ground strap or the base? Ive seen some charts and they show being able to see 2 timing marks on the ground strap?
  20. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    Whats the benefit of a non projected plug? Also what is the determining factor or what you look for to determine heat range?
  21. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    Can you break down what exactly you are seeing and what i should look for? Too rich at idle? Also too much initial timing?
  22. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    These plugs are a little over 2 years old, no change to carb or anything else since, have been using vp 96 octane non oxygenated fuel for about 6 months. The plugs have never looked that good, they have been pretty much all black on 93 non ethanol
  23. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    3 different plugs ground strap pics without flash
  24. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    Cylinders 2 4 6 8 Cylinder 2 Cylinder 4 Cylinder 6 Cylinder 8
  25. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    Heres plugs from Cylinder 1 3 5 7 Cylinder 1 Cylinder 3 Cylinder 5 Cylinder 7
  26. 71DodgeDemon340

    Read my plugs, was carbon fouling on 93 pump gas but not on 96 vp?

    Hey guys i just was wanting to get some guidance on this subject, ever since i had the 340 in my demon rebuilt when i restored it the plugs always look carbon fouled, ive never had a miss caused by it but they always look black. I change them every 2 years and never have a issue, im just wanting...
  27. 71DodgeDemon340

    Best cap and rotor for factory style electronic distributor?

    Seems like the accel is the only widely positive reviewed available
  28. 71DodgeDemon340

    Best cap and rotor for factory style electronic distributor?

    is the accel cap and rotor about the best one available for the factory style distributor?
  29. 71DodgeDemon340

    Best car cover you use for your mopar?

    Surprise surprise look what showed up today. I was under the impression that it was going to be 3-4 weeks. Im pretty happy with the covercraft custom fit cover, they did a good job on adjusting for the rear go wing with the measurements i provided. The front is just a tad looser than i would...
Back
Top