Search results for query: *

@Oldmanmopar Thanks for that info, the k-member should be good and straight (or so I hope) as I switched from the original /6 to v8 member that bolted up nice and straight without issue. I'll take that measurement though to be on the safe side.

Managed to do some quick measuring. The top of the frame horn comes in right at 34 5/8 while the bottom is at about 34 5/16.

Thank you @Oldmanmopar I appreciate it. @Dana67Dart I'm going to have to look at mine again. @glenn340 Thank you for that picture on yours. I will have to test fit my new AMD piece again and check measurements again. I ground down the areas where the spot welds were and will mock it up again.

Thank you for that!

Looking for a few measurements if anyone has them available or can assist. I'm in the process of replacing the lower radiator support with an AMD piece, I noticed that spacing between the rad support and the frame horn on driver side was wider than on the passenger side. Trying to see if I need...

Good point, thanks. Updated original post to 318 engine with 727.

Looking to purchase the torque shaft and gearshift control lever for an automatic console. 318/727 combo.

2099 S 10th St Unit 40, San Jose, CA 95112 If you look them up on Instagram they post up when the next event is.

Nice! Looking forward to seeing the progress! You anywhere near Sprint Motorsports? They usually have a cars and coffee once or twice a month.

Sent you a PM Nope, can't post emailaddresses.

Pm'd you both.

Auto shifter items no longer needed. Looking for 8.75 pinion snubber and shock mounts. Thanks Mike

71 Duster fuel and temp gauges?

Have a power steering gear box in good condition?

disk brakes? Looking for gravel shields.

Looking to buy some dust shields for my 1971 Duster front brakes.Thanks!Mike