Search results for query: *

Convert Your Car To Alcohol

Convert Your Car To Alcohol

My carburetor is carter 2BBL and my engine 318ci. What are the modifications to use Ethanol (E-85)?

A friend, Have Coronet not with 2bbl but 1bbl carburator ( So no problem with metering rod) . He take only jet 20% bigger (58 to 72) and that's work fine with éthanol. My problem is to find the good metering rod size?

I don't understand this: "IMHO the metering rods and the Jets combined are the total orifice size. The hole area minus the rod is is the total area of the orifice. I don't understand this:"IMHO the metering rods and the Jets combined are the total orifice size. The hole area minus the rod is...

Hello.My car is stock with 318ci engine and a 2 BBd carter carburetor. To run with E85, I read the jets must be changed (Diameter size + 20%). Do you know if the metering rod should also be changed too? And how much?

Ethanol E85

Borgeson advised me to drain the ATF oil that I had used for a mineral oil. I will try and then I will advise.https://www.amazon.com/dp/B00BK7MFBY/?tag=joeychgo-20

I contacted Borgeson and they anserwed:"We do not recommend you use ATF. We recommend using a non-synthetic power steering fluid."So ,do you know what oil?

I contacted them and they will give me an answer tomorrow

Thank you but all this is complicated for me.I will look for a kit.

Borgeson sell new steering pump hoses for Saginaw only .My steering pump is Fédéral.How to connect the federal pump to my new Bogeson steering box?

I still have the problem. I start the engine and after 5 minutes, the oil is boiling and the steering pump overflow.

Not a lot of explanation at Borgeson.Too bad.

I understood the problem.Borgeson steering box have the assembly of inverted hoses. I had not seen it.Low pressure: left and: high pressure right.

I changed my steering box for a Borgeson. Problem: The oil is boiling and there is a noise all the time. Do you know what is the problem?

I disable the old regulator and connect like this and it works fine. Thanks a lot for your help.

"Did you disable the original regulator inside the fuel gauge?" No,only small wire is cutting but I will disable. "The lug is still there covered with the plastic screw on protector." Yes but the lug with the plastic screw is for the gas gauge not the régulator?

68 wiring

Big problem. I followed your photo of cabling and the regulator warms itself enormously and all the gauges rise at the most?

Ok thanks.

Hello. I do not remember where connect this on my cluster?

Not useful now, I understood the connection.Thank you.

. A and B are bolted on the same way so why did you put two wires to the regulator? Where do you connect C? 12V?

Thank you for all these explanations but I'm not very good in electricity. Can you trace the wires in the photo?

Yes but you do not have the same regulator as me. Mine is the same as the old one with just 2 studs. So if I connect it like the old one, it should work?No?

1963 Dart exemple.Early A-body Instrument Regulators

Hello, I replace my defective internal gauge regulator with an external one.My problem is to connect it.Do you think it needs to connect: A with B and C with D or A with D and C with B? Thank you