Search results for query: *

I had new gears put in,the other ones were shot,even ruined a perfectly good 489 case so had to get another.The rearend is a 83/4.Been reading online that Richmond gears all whine because of the material in them for racing.

Back again guys.I just did my 318 over,rear end has a set of Richmond Gears,355 with sure grip,and a 4 speed.I put the car back together and now i have a vibration and a whine in the rearend when you let off the gas,no very little noise under load.The axles also have green bearings on moser...

Clutch going bad on the Duster and was wandering about a 3 finger zoom clutch.The motor has around 310 hp with 355 sure grip.Thanks David

Would a 1969 318 crank out of a automatic car have a pilot hole for a standart transmission.Thanks David

The throw out bearing makes a noise with clutch out and stops with clutch in.It is a 10.5 on a 318 motor.Tried adjusting with only 1/2 pedal made a little differance but if i adjust it any more the pedal will be 3/4 down to the floor before it engages.I still have the overhead spring in it...

Thanks Kim,i think ill just leave them in

thanks for the input Dartnut.There are no end play adjuster on either axle so im thinking they might be green brgs.I wonder if you can but the right brgs for these axles.Ill have to call tomorrow.Later David

I have a 74 Duster that started howling when under load and quite when you let off the gas.Took center section out to check it and found out i had moser axles in the 8 3/4.Now i need to find out if these are the green bearings i hear are no good.There are 355 gears with a shir grip.Any help is...

will 10 inch backing plates and drums off a 71/4 fit a 83/4.Going in 1967 dart.