Search results for query: *

Did the voltage drop test and found that I wasn't getting enough supply. Swapped the cables and got the same result. Swapped the battery from my dart and... voila. Turns out the brand new battery was actually a lemon.

Alright I discovered that my battery charger was actually broken and reading improperly. I swapped out chargers and I now have power to the truck. I'm not able to get it started though. It'll crank once then click. I took out the starter and had it tested today (looks to be the original). It...

all the grounds we're checked and cleaned with some 320 sandpaper. Still no power. After the battery swap didn't work the grounds were the first place I checked.

Although it's not an A body, it's still mopar so I figured this question would fit nicely here. I just came home after a 3 month period overseas and my 99 dodge 2500 v10 is completely cold iron. So without hesitation, I tossed in a new battery and attempted to fire it up. Nothing. Took the...

Ok, I see the brake switch leading into the turn signal and I see the left kick panel. Everything is still intact there but, I don't have any power going to the original wiring. The 3 bulkhead connectors in the engine bay are disconnected. I couldn't imagine one of these would be a power...

So I'm holding my old engine bay wiring harness and I know there's got to be an easy way to get power back to my taillights. I yanked my harness out years ago and hot wired the car to drive it (see picture) but, I need those taillights to avoid pricey CA tickets. Now, I havnt touched the wiring...

Ok, I found out that the problem is my bulkhead connector. Half of it was melted and the prongs were set back. The ignition wire was barely connected. Now, my question is... where can I get a replacement? Is this connector something I can get at Autozone? or am I going to have to special order...

I had this exact same problem with my 68 barracuda. When i bypassed the ignition it would crank. For me it was the connector at the firewall. It looked fine from just looking at it but when i unplugged it I notice that part of it had melted and that the prongs had been set back and where not...

anything?

the connections on the firewall are all connected. the alternator connections are just fine. The negative cable is brand new and is hooked up well. Same with the positive. the starter wires seem fine too. Is there anything else that would cause no power within the car? The dome light isnt even...

Hello, ive got a 68 barracuda 318/904. My car is in rough shape but until now it ran. Im not getting any power throughout the car. the battery has a full charge, and the ground cable had a solid connection. what else could it be? I havnt done anything to the car since it was running last week...