Search results for query: *

I bought a 69 swinger new in Sept. of 69. It had a sticker, not an emblem, on the front fender.

Would 68 hood inserts fit a 67 hood? And does anyone make reproduction 68 inserts?

My 67 cuda vert has that same moulding, it just uses clips that pop into holes, no studs, I just used a putty knife to get it off the door.

Thanks for all the replies. I was sure someone here would know. Somewhere in my cars' past life the dash bezel was rechromed but the bottom part was not repainted, so when the sun hits it just right I get momentarily blinded.

Is argent available anywhere in a spray can?

If you look at the 3rd photo you see the vent window piece with the latch on it has a stud sticking off the bottom of it that fits through the vent window frame and has a clip (also in the 3rd photo) that retains it. I don't know how you would get at that clip in the car. I just took the drivers...

I pulled the window felts off my 67 Cuda by levering them in with a putty knife and then used needle nose vise grips to pull them off, they just clip on, no screws involved. Of course this trashes them, not sure how you'd get them off intact, mine needed replacing anyway. I got a complete set...

Restoration Specialties in PA. has a wide array of stuff like that available. They also have window run channel and lots of different kinds of clips to hold trim on. Since you're not concerned about saving the old one I was able to use a small screwdriver and open a gap so I could grab it with...

I am going to replace the drivers door on my 67 cuda vert. I have gotten it apart to the point of removing the glass. I have a 67 shop manual but it does not cover Barracudas. What is the sequence for dismantling the rest of the door? I scored a really nice solid replacement door from FABO...