Search results for query: *

amazing. :banghead:

haha' thanks for the laughs

Vapor lock sucks The motor cranks and it turns on while the key is on the on position but as soon as you let go the car turns off. Get a carburetor base plate that doesn't transfer a lot of heat Reroute your gas lines away from heat and cover them More times than none this is also an...

no way.... sometimes it is yes i agree but most are not this easy. mine wasnt anyways, and after many new parts and upgraded ignition it started just fine. . . not really knowing what the culprit was.

GOOD TO HEAR... great job. do you know for certain what it was?

****** apart of course from me moving my gas lines away from heat source and getting a new carb. Base plate that doesn't generate as much heat .... has been spot on so far.

"starts while cranking" lets go of key on position and shuts off.... doesn't that sound like vapor lock? same problem i had. i ended up replacing a lot of things... what did the job i think was replacing the ICM, reluctor and pick up coil. careful where your gas lines are running through.

can you provide a video? now it is starting to sound like vapor lock. maybe electrical. if it wont turn over id check proper connections to starter & grounds (maybe bad starter) i changed my starter wire because it was really corroded inside the sleeve couldn't tell from just looking at it...

its not vapor lock because its dying at idle - if it was vapor lock or fuel boiling git would only turn on then immediately off after key on position is released... tune the carb and set your idle screw. and check for leaks.

sounds like fuel/air ratio and/OR your timing. have you tried bumping up the idle screw ???