Search results for query: *

nope, oil plug is in; plenty oil to right rockers just none to the left. Thanks, Tim.

Thanks Tony, I'll give it a try, easy enough.

The oil hole goes thru the stand and angles past the head bolt. I measured the distance from the stand to the top of the lifter, added for the lifter height and found the length of wire I could feed down was the same. Not quite sure where else the wire could have been going except down the oil...

Thanks for your reply. I've rotated the motor 20* past tdc after the compression stroke of #6 cylinder, (the location where there should be oil going to the left rockers) and turn pump with a shaft and drill. No luck, must be either cam bearing or possibly faulty cam, (holes not drilled all the...

Will check it again, can't hurt. thanks

Got it, thanks. So I'm thinking the next move would be to pull the head; sure beats pulling engine for cam bearings.

Would a blown head gasket cause it to not get oil to the rockers?

Thanks, appreciate your reply

Thanks to all that've answered. The shafts are on correctly and I'm aware of the cam position and it only getting oil once per revolution. Didn't know of the oil plug but will check this out. I'd rather it be almost anything but the cam bearing. Thanks again!

Brand new Harland Sharp shafts and rockers, not clogged shafts..

Have a 69 Swinger 340 that has very little if any oil getting to the left rockers. Right side is getting plenty. It's not the shaft,it's on correctly, notch forward and down. The rocker shaft pedestal, (2nd back from front) that feeds oil to the shaft appears to be clean. Question, should I be...