Search results for query: *

No, I don't have any pictures of mine and I'd have to pull up the carpet, but that looks good. The only difference being my connectors were 2x3 tubing and my floor was cut in such a way so that it could be welded to the tubing. A pain in the *** and time consuming. Also some bore a hole in the...

Yes. I have a full cage and connectors. The connectors are 2x3 tubing and the floor boards were notched so they run through them and are welded to them also. The cage is a modified SW cage.

Moser axles are $315.00 a pair plus anether $100 for bearings,retainer plates, and wheel studs. I think MW axles are a lot more expensive but not necessary. I was very happy with the quality of the axles I got from them for my Dana. I also had a set in the 8 3/4 thet was in the car before the...

Moser axles are the best bang for the buck. I love your car by the way. My first car was a 69 Barracuda with a 340, 727. B5 blue exterior, B5 blue interior. Have i mentioned I like your car?

If it is a stock type bearing the outer race will come off the bearing to be pressed into the axle tube, also if is a stock type bearing it will be a tapered roller bearing. Green or non-adjustable race bearings are an assembly that can not come apart and usually have a thin snap ring or c-clip...

I have heard that quality has gone away since they started having them made in Mexico. I've heard of sagging problems and also breakage in higher powered vehicles. I have Mexican made Super Stock springs in my car that I bought new in 2001. They haven't started sagging yet but my springs don't...

On my 70 duster street car i just installed 225-70-14's and wanted 235's but couldn't find any in 14 inch. This is with a b-body rear. They will fit with a a-body rear also. A 235 70-15 may be a tight fit, but i'm not sure, but i'm sure there is someone here that knows. Now if you want to know...

When I was running a snubber I tested settings at the track one day. Tried preloading the snubber which was terrible,made the car bounce and kinda hop. Lowered to about 1/4 inch clearance, acted better. I had already shortened the snubber to fit the car so I cut the rubber part down so I had a...