Search results for query: *

Mopowers - No problem at all! I know you were not personally trying to start a debate, but you know how some guys get in this forum so I wanted to make sure I was explaining it correctly! I always like to give references and pictures with what I try to explain. I was taught this rule in the...

OK I just did an experiment and here is what I came up with. Check out this website: http://www.cncexpo.com/TorqueAdapter.aspx Measurement A = 90 Measurement E = 5.5 Measurement L = 17.5 Measurement D = 25 The result holding my torque wrench at 90 degrees came out to 25 ft lbs...

I was always taught if you hold the torque wrench at a 90 deg angle to the crowsfoot regardless of horizontal length, there is no torque multiplier as you are not increasing the vertical distance from the fastener when you are applying torque. Correct me if I'm wrong? I see a possible debate...

Here is one I fabbed up when I was torquing down my Air Gap intake. I could not get a torque wrench in the middle sections at all so here was my fix!

Nice job! I wish I would have seen this the other day when I was cursing at my torsions being stubborn!