Search results for query: *

I have a JVX Racing Transmission, works very well. Full manual valve body with transbrake. However, I was wondering which are your suggestions to drag performance 904/727 Torqueflites shops that I can consider?

Currently running a 4.11 rear end gear. My trap speed is 127 mph. A999 with 1:1 3rd gear. 29 inch slicks. My rpm at the finish line is 7200 rpm. Would like to lower my rpm to around 6500. What rear end should I use? I tried different calculators, but when I plug in my numbers, the current gear...

Hi, During my last race a few weeks ago, we noticed that after a run we had trans fluid leaking from the torque converter / bell-housing area. We assume is the front pump seal leaking. However the oil does only leak after a hard run pass on the track, not under normal driving or at idling. I...

Hi, I have a build A999 trans with trans brake and manual valve body. I just start racing the car a couple of months a go, and my burnt out technique was to stop in the water, start burnout in 1st gear, then after a couple of second shift into 2nd and when the tires start to create smoke I let...

I have a fully build A999 trans, we just have made about 15 passes on it. Sometimes when I shift into 1st gear the engagement of the trans does not take place right away. I rev the engine, and like after a second or so the car start moving. I have verified the oil and the trans is full, I...

Hi, Haven't been able to get an answer from JVX to purchase the installation kit 79522 for my shifter. Do you guys know where else can I purchase this kit? Is frustrating calling and sending e-mails with no response

I have purchased an flexplate from Hughes, the brand is PRW. Hughes Engines The intention is to be used with my Small Block Eagle stroker kit. When using the eagle stroker crank ( internal balanced ) is there any special flex plate to be used? Is there any difference in the crank bolt...

Guys, This transmission has been sitting for about 15 years, with all his plugs installed on the inputshaft and at the outputshaft. On the outside the trans has some paint deterioration, but to be honest I was surprised when I drop the oil pan, it looks intact, no rust and very clean. The...

Guys, I found a good deal on a "new" JVX Racing Fully Build Transmission, it has full manual valve body, transbrake and capble of handling @ 700 hp. The " downsite " of it is that has been sitting and stored for about 15 years.... All the internals are brand new as this transmission...

I am building a 700hp small block engine. Was wondering what is the best option i have for a transmission. Because of the engine being installed on a small body I would prefer to stay with a 904. Ideal will be for the transmission to withstand long bracket racing seasons, equiped with...

Hello, Gents, I am starting the build up of a 408 stroker engine and we are looking to get around 500 hp and about 600 ft/lb of torque. Course this is going to be with +-75 shot of nitrous. What we are looking is if the 904 can handled this amount of torque or should we go with the 727...