Search results for query: *

this is project i've been wanting to do for sometime. Its something I am glad me and my dad are getting to do toghether. its been great bonding time. heres a few sneak peaks into this machine. any guesses as to what it is? lol... It is starting out with a 1971 360 block. its getting main studs...

I'm building a internally balanced 408. Pump gas aluminum headed motor. Gonna be over 600hp. Is there any oil mods you all would recommend I do before assembly and machining.

I am getting ready to build a new motor for my duster. it has a .030 over 360 now that runs on pump gas and has run a best 11.92 the motor has less than 500 miles on a refresh. I am gonna pull it and sell. do you think $1800 is a fair price for my old 360? has ported 2.02 J heads. moroso deep...

i have put my 360 from my drag car into my street car. i had a truck rear sump pan on it in the drag car and now i have a center sump moroso on it now. my question is: I have the tall dip stick tube, so how long is the dip stick for a center sump pan with tall dipstick tube. all my other parts...

last fall i bought a set of edelbrock performer complete aluminum heads and a performer air gap intake for a small block for $1000 all new in the box. a guy was needing some money. my question is: Do I leave my ported 2.02-1.60 J-Heads on my small block with the m1 intake or do i install my new...

today we fired the new big block in my 74 dart swinger. it has: 14.5.1 forged domed ross pistons m1 intake, ported and polished factory heads-flowed upper 290's 284 dur.-690 lift ultradyne roller cam comp roller lifters .30 over motor msd ignition eagle h beam rods balanced steel crank...

i just installed the #'s matching 360 back into my 74 duster. put some flat top 9.5.1 pistons with the 284/484 drag comp purple shaft cam. it is on top dead center,intake is sealing fine, it will not run at 10-12* at idle. i adjust it to 32* at 2000rpm. it will idle then die. will not stay...

tomorrow i will finish assembling my new 440 for the dart.it is .30 over.has 13.5.1 forged domed ross pistons,452 heads.flow over 309 at 680 lift.has a bullet .675 lift full roller cam,lifter,rockers,etc.crank is turned .20.steel. fully balanced,has eagle h-beam rods.aluminum w/p...

i have a 360 duster.when parked at a stop light with wet pavement.i can floor car and will take off pinging and spark knocking w/out spinning the tires as soon as the car reaches 3000 rpm's.it breaks the tires loose and is all over the road.it is a stock 360 less the 340 cam.has factory 4 bbl...

After 6 Years Of Sitting On Stands In The Back Of The Shop.we Finally Started The Engine In My Fathers 64 Sport Fury.had To Blow Out The Fuel Lines And Install My Carb.but It Fired Right Up On Carb Cleaner And Once It Primed The System The Car Ran Excellent.lifter Chatter For Couple Of...