Search results for query: *

Is missing the bushing on the rod ? is it possible to just replace the bushing or does the entire striker need to be replaced? The door is vibrating at the striker because the bushing is gone. I have not found either a bushing or a striker in line.. Does anyone have some guidance for me..

On a 1967 barracuda does the headlight bezel go on first or the grille? I am putting them on, after paint, and I can't remember the order. I have the grilles on but it looks like I won't be able to slide the joint from the bezel onto the grille. It also looks like if I put the bezels on first...

Does anyone have any experience with reproduction exterior door handle for 1967 Barracuda? I purchased a set from New York restorod and was very pleased with their appearance and quality. Yesterday, in the process of putting parts back on the car, following new paint, I installed the passenger...

Can the studs, pins or whatever the proper term is for the attaching pot metal studs on the inserts be repaired? Both of my inserts have 3 and 4 broken off. Also the grilles have about 5 of the studs missing from each of them. I think I can figure something out for the grilles but I haven't got...

At the top of the window channel and vent window there is a black rubber stop that is shaped to fit the front edge of the window glass. I am replacing the channel runner for the window and this piece is damaged on my car. Does anyone know of a source for this piece? It fits on top of the chrome...

Need information on where to locate the attaching plates for this piece on the trunk. This is the wide trim plate on the trunk not the trim pieces. I have searched and cannot find them. Any clues???

I am just wondering what I should expect from a 4k paint job. I have talked with the shop and they say that they will remove fenders, doors trunk and hood. Repair minor rust damage to lower side panels in front of rear tires, (new metal), repair trunk and install missing trim to trunk, (I have...