Search results for query: *

http://www.foxnews.com/leisure/2013/09/25/ford-racing-unleashes-its-biggest-small-block-ever/

Is spraying the gaskets with something a way to have a better chance of making a good seal on a block that is not freshly decked? My deck was minimally machined and not all of the surface was touched, by the previous owner and his builder. I am only replacing the heads / cam and am not...

I am in the process of upgrading my 416 from hyd Comp PP 508 to a solid rolle voodoo and will be racing it at first, then putting the moter in my street/strip fish. Engine will be revved to 6500 max now instead of over-revved at 7000 with the hyd's. It has the MSD 7A and blaster 2 currently...

So while my stroker is out of the fish and getting ready for the next ride (race Demon) I decide to pull the intake and see how the cam looks - was good as far as I can tell but I am not sure what to look for anyways. The wear pattern was all the way across the lobe tip if that matters. Also...

The car I bought from a friend's widow just had a purple 508 cam installed. The guy never heard it run before he died but he did leave a note saying to use Valvoline 20-50 ZR-1 with zinc. The local speed shop is a Mopar house and they carry and recommend Brad Penn 20-50 green oil which I ran...

It is worse if I idle it then shut it down rather than rev it and shut it off while it is still revving. 10-1, 93 octane, recent build. I am thinking hot spots but the combustuion chambers looked pretty smooth to me. Spark plug heat range? Ideas? I know this is not a good thing for...

If therer is such a thing as a "performance" spark plug. My stroker was bought with the same Autolite 3922 plugs it was dyno'd with 3 years ago. The plugs read pretty well as best as I can tell and I have ran the engine at the track with the same ones. MSD 6AL MSD wires and MSDand Blaster 2...

The gaskets I have have ears on each end that correspond with the water holes between the block and the heads. On one end the ears have the hole for the water passage and on the other end the ears do not have the holes. Do the ears with no holes correspond with the rear of the engine and...

I have the heads off the stroker I bought here: http://www.forabodiesonly.com/mopar/showthread.php?t=154286 To get the springs checked to be sure their tension has not dropped and to get them flowed. So looking into the cylinders I find a bunch of wear where the piston skirt would rub. There...

500 HP at 5600 / 500 Ft-lb 4800... with a Victor single plane 830 Holley ported Eddy heads. What difference would the Air Gap make?