Search results for query: *

All, I have a 1965 Dodge Dart with a rebuilt engine and transmission. New fuel pump. Gas tank, filter, car runs great but uses a lot more gas then what I think it should. Is there an adjustment that can be made, I get about 200 miles on a tank of gas. Any suggestions would be helpful...

I have a 1964 slant 6 225 1 barrel carb. The air filter housing that came with the engine is of course round in shape with an outlet for the breather cap. However the bottom piece that holds the filter is tight to the carb. When I put the top on and tighten the wing-nut as far down as I can the...

What is the best rebuild kit for a 1 barrel Holley carb?

I dropped the old gas tank trying to instal a new tank and sending unit. The new tank I put the sending unit in and now the question the lock ring appears to have 2 tips one more pronounced than the other tip does the bigger tip get placed inside the bevel on the tank or does one tip go on one...

okay so tonight I'm going to drain out the gas in the tank and attempt to replace sending unit. The one in there looks like it has little tabs around the outside to possibly tap a screwdriver or brass tool to turn. However the new one doesn't have any place to tap tight. Has anyone come across...

Has anyone done this before? What are some of the trinks in getting the old one out and the new one in? Ay help would be helpful and appricated. Thanks again 1965 Dodge Dart Convertible....

I'm replacing the fuel tank filler gasket and I didnt see where the vent tube ends up. Does it just go through the trunk floor and hang around there underneath? I got the new gasket in and just awaiting someone with knowledge on this so I can proceed. Any info would be terrific... Thanks in...

Do I have to remove the gas tank to change sending unit and filler gasket? I'm not sure where the sending unit is located but if I don't have to drop tank that would be a bonus !!!!!It is in a 1965 Dodge Dart 270 Convertible......

I need to drop the tank I think since it leaks right where the filler tube enters the tank. I got a new gasket and since sending unit isn't working I got a new one also. Do I need to drop the tank and if so how hard is it to do? Thanks for anyone who answers.... Thanks Bill Dart owner and...