Search results for query: *

Ok it's got a trans go shift kit. Bb 727. First is good. Second is good. Reverse is good. All hard shifts. Third basically just slides in but have to let off the gas so it goes in. Fluid looks good znd clean. Levels were fine also. Dropped pan and nothing in it. Before I pull tranny is there...

Is this too much Stall for my Street car and some time at the track. 525-550hp 440. 28 inch tall tire and 410 gears, 72 duster. Stalls at 3500 http://www.jegs.com/i/TCI/890/143100/10002/-1?parentProductId=749012#moreDetails

can anyone give me some advise on a rebuild kit for one of these. It will be pretty much street but will see some track time for fun only. 440 duster, 410 gear, 28 inch tall tire, around 525-550hp. Thanks

My Axels are too long, the rear end has been shortened to 53 inches, not sure why, But this is how my brother-inlaw purchased it. I have B body Axels which are 5/8 too long. Can I safely cut this much off without resplining them, they are tappered up too the spline, not enough too respline them...

I Have my 8 3/4 in the machine shop to get shortened, he needs the sure grip out to run a bar threw to keep it true, how hard is it to take out, never had one out before.

OK here is the problem, put in gear, drive shaft turns but will not move car under load. New 727 tranny, rear end just put together ,not by me. Axcels are the right length and housing is too. lift car up and tires will turn, is there something wrong with the third member?

Here is the problem, tranny shifts fine but will not move the car under load, lift the car up off the ground then moves correctly forward and reverse, this has new tranny fluid and it is full. Checked when hot. Its a SB 727 with reverse valve body. Is this the clutches gone bad?

Can Someone Tell Me If The Linkage That Runs From The Tranny To The Steering Colum Is Different From A 318 To A 904 And A 360 To A 727, It,s In A 74 Duster.

OK I Am Ready To Set All My Lash On My Rods On My 440. Is This The Way You Do It.tdc #1 Firing, Set In #2 And Ex #8 Rotate 90/deg In #1 And Ex #4 Again Rotate In #8 And Ex #3 Again Rotate In #4 And Ex #6 Again Rotate...